1.10. CE-conforming equipment Introduction 1.10.3. Manufacturer-supplied CE-conforming equipment The responsibility for observing valid regulations in the case of wheel loaders with "interchangeable equipment" (e.g. bucket or fork-lift) which was not supplied from works lies with the customer which was subsequently fitted to the machine. The guidelines for CE Conformity and road-traffic registration are deemed to have been fulfilled when the manufacturer of the equipment confirms fulfilment of the document 42T-93-21070. The certification must be sent to the customer and the wheel loader manufacturer.
The CE conformity declaration for a specific wheel loader is only legally valid once this has taken place. The dimensions X1, X2, Y1 and Y2 must be provided by the manufacturer of the equipment for approval for use on public roads. The dimension Sh (smallest tyre radius) must be added to the dimension D2. The figure G (in kg) represents the maximum load (equipment and operating load) which may act upon this point. 1-26 WA100M-5 – VEAM280201