THROTTLE 4.4 Throttle Rod Replacement Seat assembly 1 Raise the boom arms, engage the boom supports and shut off the engine. WARNING Safety switch wiring connector Never work under the boom arms without the boom supports engaged. 2 Remove the seat and hydrostatic shield. 3 Remove the set collar connecting the throttle rod to the throttle handle. (fig. C2029) Push the rod out of the lever. 4 Open the rear door and remove the rear most set col- lar from the throttle rod. (fig. C2016) 5 Remove the throttle rod from the engine lever pivot. 6 Pull the throttle rod out toward the rear of the loader past the radiator. (fig.
C2031) 7 Remove the set collar left on the throttle control rod and transfer it to the new control rod. 8 Replace the throttle control rod in the reverse order above. 9 Adjust the 2 set collars, on either side of the engine lever pivot, so the engine lever contacts the limiter bolts when the throttle handle is stroked in the low idle and high speed settings. (forward and back). (fig. C2016) C4280 Under side view of throttle lever handle Throttle lever 4 Throttle rod Set collar C2029 Set collars Limiter stops C2016 Throttle rod C2031 4-23