EVERY 250 HOURS SERVICE Carry out the following maintenance only after the first 250 hours. . FUEL FILTER, REPLACE CARTRIDGE l ENGINE VALVE CLEARANCE, CHECK AND ADJUST EVERY 500 HOURS AND 2000 HOURS SERVICE. For details of the method of replacing or maintaining, see the section on a. 1. FINAL DRIVE CASE Set the UP mark at the top, with the UP mark and plug (P) perpendicular to the ground surface. 2. Remove plug (F), and check that oil level is within 10 mm below the bot- the plug hole. tom of the plug hole. If it is not within this range, add engine oil through * turn, then check the oil level again.
If the inspection shows that the oil level is low, turn the sprocket one * The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. b. ENGINE OIL PAN AND FILTER 1. Remove drain plug (P) under the chassis, drain the oil, then tighten it 2. again. Using a filter wrench, remove cartridge (1) of the engine oil filter by turn- 3. ing it counterclockwise. Clean the filter holder, coat the seal surface of a new filter cartridge with * When installing, tighten until the packing surface contacts the seal surface engine oil (or coat it thinly with grease), then install. 4.
After replacing the cartridge, pour in the specified quantity of engine oil of the filter holder, then tighten a further l/2 turn. through oil filler (F). 5. that the oil level is correct. For details, see CHECK BEFORE STARTING. Run the engine at idling for a short time, then stop the engine and check * * The type of lubricant used depends on the ambient temperature. Select Refill capacity: 18.5 Q according to the table “FUEL, COOLANT AND LUBRICANTS”. Be sure to fit a genuine Komatsu cartridge. operated. Replace once every 6 months, regardless of the number of hours When supplying oil, be careful not to get oil on the alternator. will spill.
Wait at least IO minutes after stopping the engine before replac- If filter cartridge (1) is removed immediately after stopping the engine, oil ing the filter cartridge. Use API category CD class oil. If CC class oil must be used, change the oil and replace the oil filter at half the usual interval. - 128-