Komatsu — EVERY 500 HOURS SERVICE

c. FUEL FILTER 1. Using a filter wrench, remove cartridge (1) by turning it counterclockwise. 2. Fill a new cartridge with fuel and refit it after applying a dab of oil to the packing face. * To refit the cartridge, place the packing face in contact with the seal face of the filter stand, then screw up the cartridge about 2/3 of a turn. 3. After replacing the filter cartridge, set the fuel control dial to the low id- ling position. 4. Turn the starting switch key to the START position, and turn the starting motor for 15 - 20 seconds to crank the engine and bleed the air. A The engine may start, so check carefully that the area around the en- gine is safe before starting to crank it.

* If the machine runs out of fuel, use the same procedure, and crank 3 - 4 times for 15 - 20 seconds each time to bleed the air. * Do not continue to crank the starting motor for more than 20 seconds continuously. Wait for 1 - 2 minutes before turning the starting motor again. * The air bleeding operation can be carried out more quickly if the fuel tank is full. t After replacing the filter cartridge, start the engine and check that there is not leakage of oil from the filter seal surface. t Be sure to use a genuine Komatsu cartridge. * If a pre-fuel filter is installed, replace the pre-fuel filter cartridge at the same time.

If the ambient temperature is below 0°C or if a water separator is in- stalled, bleed the air as follows. 1. Loosen the knob of feed pump (2), pump up and down 5 - 6 times to bleed the air, then push in the knob and tighten it. 2. Carry out the normal air bleeding procedure to bleed the air. * If it is difficult to start the engine, carry out Step 1 again. - 136-