EVERY 1000 HOURS SERVICE t Maintenance for every 100, 250 and 500 hours should be carried out at the same time. a. SWING MACHINERY CASE 1. Drain off oil from drain valve (P) at the bottom of the machine. After draining, tighten drain valve (P). 2. Pour in the specified amount of engine oil through gauge hole (G). (Refer to EVERY 100 HOURS SERVICE.) The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. Refill capacity: 9.3 II * * b. 1. DAMPER CASE Remove plug (G) and check that the oil level is up to the bottom edge of the plug hole.
When checking the oil level, stop the machine on flat ground, then stop the engine, and wait for at least 30 minutes before checking. If the oil level is too low, add engine oil through oil filler port (F). If the oil level is too high, it may cause overheating, so always drain oil until the oil level reaches the specified point. The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS.” * 2. * * C. TURBOCHARGER CLAMPING JOINT Contact your Komatsu distributor for checking, or proceed as follows: Periodically inspect all joints for looseness. Tighten when necessary. Tightening torque for bolts on turbine housing side:
1.84 - 2.19 kgm l l Tightening torque for clamp bolts on blower housing side: 1.15- 1.50 kgm Tightening torque for exhaust manifold and turbine housing mounting bolts (for turbocharger mounting): 6.0 - 7.5 kgm Tightening torque for turbocharger oil pipe (inlet): 2.8 - 3.5 kgm Tightening torque for turbocharger oil pipe (outlet): 6.0 - 7.5 kgm 0 0 l -138-