1. Stop the engine. * If a corrosion resistor cartridge is installed, close valves (1). 2. Turn water filler cap (2) slowly until it comes off. A Do not remove the cap while cooling water is hot. Hot water may spout out. When removing the cap, wait until the water temperature goes down and release radiator pressure little by little by loosening the cap slowly, then remove the cap. 3. Open drain valve (3) at the bottom of the radiator and plug (4) on the side of cylinder block to drain off the cooling water. 4. After draining the cooling water, close up drain valve (3), plug (4), and pour in soft water (ex; city water) up to the vicinity of the water filler. 5.
When the water reaches the vicinity of the water filler, put the engine at low idling, open drain valve (3), plug (4), then pass water for 10 minutes through the cooling system. * When doing this, adjust the speed of filling and draining the water so that the radiator is always full. 6. When the water becomes completely clean, stop the engine, draining off the cooling water, and close drain valve (3), plug (4). 7. After draining the water, clean with a cleaning agent. * We recommend use of a Komatsu genuine cleaning agent. For details of the cleaning method, see the instructions given with the cleaning agent. 8.
After cleaning, drain all the cooling water, then close the drain valve (3), plug (4) and fill slowly with clean water. 9. When the cooling water comes up to near the radiator water filler port, start the engine, and run at low idling. Add clean water, open drain valve (3), plug (4) and continue to run water until clean colorless water comes out from the drain valve (3) and plug (4). * When doing this, adjust the speed of filling and draining the water so that the radiator is always full. 10. When the water is completely clean, stop the engine and close drain valve (3), plug (4). * If a corrosion resistor cartridge is installed, replace the cartridge and open valve (1).
(For details, see EVERY 1000 HOURS SERVICE.) * In areas where the water is hard, if there is no corrosion resistor car- tridge installed, always add genuine Komatsu anticorrosion agent KI. (For details of the adding procedure, follow the instructions on the agent.) 11. Add cooling water until it overflows from the water filler. -150-