12. To remove the air in the cooling water, run for five minutes at low id- ling, then for another five minutes at high idling. 13. After draining off the cooling water of sub-tank (5), clean sub-tank and When doing this, leave radiator cap (2) off. 14. Stop the engine, wait for about three minutes, add cooling water to the refill the water between H and L level. specified level, then tighten cap (2). b. CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT Checking Whenever the red piston in dust indicator (1) appears, clean the air cleaner outer element. Stop the engine when cleaning the element. Cleaning or replacing outer element 1.
Open the cover at the left side of the chassis, remove wing nut (2), then take out outer element (3). 3. Clean and inspect the element. (See the item “Cleaning outer element” 2. Clean the air cleaner body interior and the removed cover. 4. Install the cleaned element. for cleaning procedure.) 5. Push the dust indicator reset button to return the red piston to the orig- inal positon. * Replace the outer element which has been cleaned 6 times repeatedly or used throughout a year. Replace the inner element at the same time.
* Replace both inner and outer element when the dust indicator red piston appears soon after installing the cleaned element even though it has not * Remove one seal from the outer element. The number of times the outer been cleaned 6 times. * Check inner element mounting nuts for looseness and, if necessary, re- element has been cleaned can be seen by the number of removed seals. * Replace seal washer (4) or wing nut (2) if they are broken. tighten. * When inspecting or cleaning the air cleaner, remove evacuator valve (5) and clean with compressed air. -152-