g. REPLACE BUCKET TEETH (VERTICAL PIN TYPE) (except PC200,2OOLC-5 MIGHTY) Replace the point before the adapter starts to wear. * Set the bucket so that its bottom is horizontal. 1. Use a hammer and drift to drive out lock pin (2), which is fixing point (1) to the bucket. (If the drift is struck while facing rubber pin lock (3), the rubber pin lock may break. Direct the drift to the back of the pin.) 2. Check lock pin (2) and rubber pin lock (3) which were removed. + If the lock pins and rubber pin locks with the following defects are used, the point may come off the bucket. Replace them with new ones. 1) A lock pin (a) which is too short.
(When aligning with bottom face (c), clearance (b) becomes more than 1/3A.) 2) A rubber pin lock, the rubber (d) of which is broken and whose steel balls come out easily. 3) A rubber pin lock, the steel balls (e) of which can be buried by being pressed with a finger. 3. Clean the surface of adapter (4) and remove the soil from it with a knife. 4. Use your hand or a hammer to drive rubber pin lock (3) into the hole of the adapter. Take care that the rubber pin lock does not project out of the adapter. 5. Clean the inside of point (1) and install it to adapter (4). If it is stained with soil or has projections (f), it will not fit to the adapter. 6.
Fit point (1) to adapter (4), and confirm that when the pointer is pressed strongly, the rear face of the hole for the pin of the point is at the same level as the rear face of the hole for the pin of the adapter. * If the rear face of the hole for the pin of point (1) is projecting from that of adapter (4), do not drive in the pin. Instead, find out what substance is preventing point (1) from fitting to adapter (4), and remove it. Then fit point (1) to adapter (4) and drive in lock pin (2). 7. Insert lock pin (2) in the hole of the point and hit it until its top is the same level as the surface of point (1). 8.
After replacing a bucket tooth, confirm that it is installed securely by doing the following: 1) Confirm that the surface of the lock pin is secured against the point. 2) Lightly hit lock pin (2) in the reverse direction from which it was hit in. 3) Lightly hit the tip of the point from above and below, and hit its sides from right and left. 4) Confirm that rubber pin lock (3) and lock pin (2) are set as shown in the figure. * The life of the point can be lengthened and the frequency of its replace- ment can be reduced by turning it upside down so that it will wear evenly. t When replacing the point, replace the rubber pin and lock pin with new ones. This will prevent the point from falling.
- 160-