Komatsu — WHEN REQUIRED

h. CLEAN LINE FILTER If there is any abnormality in the pump or other hydraulic equipment, remove the dirt from inside the line filter. * Before removing the line filter, release the pressure inside the hydraulic circuit as follows. Rleasing pressure 1. Lower the work equipment to the ground on a firm, flat surface as shown in the diagram, then stop the engine. t Set the lock lever to the FREE position. 2. Operate all the work equipment levers to the end of their travel within 5 - 6 seconds of stopping the engine. 3. Remove the cap from the hydraulic tank. 4. Start the engine, run for approx. 10 seconds, then stop the engine. * Do not run the engine at above 1000 rpm.

* Place the work equipment levers at neutral. 5. Operate all the work equipment levers to the end of their travel within 5 - 6 seconds of stopping the engine. * Repeat Steps 4 - 5 three times. A When removing the oil filler cap from the hydraulic tank, turn it slowly to release the internal pressure, and remove it carefully. Method of cleaning 1. Remove case (I), then remove element (2) and clean it. Sr Some of the oil inside the piping will come out, so prepare a container to catch it. * Remove the dirt stuck inside the case. 2. Install element (2), then screw in case (1) to install it. * Replace o-ring (3) and backup ring (4) as a set when reassembling. * Tightening torque Case (1):

4.5 k 0.5 kgm * After reassembling the line filter, start the engine and run at low idling for 5 minutes to bleed the air. It is not necessary to operate the control levers to bleed the air. i. DRAIN WATER FROM WATER SEPARATOR When float (2) is at or above red line (I), drain the water according to the following procedure: 1. Loosen drain plug (3) and drain the accumulated water until the float reaches the bottom. 2. Tighten drain plug (3). 3. If the air is sucked into the fuel line when draining the water, be sure to bleed the air in the same manner as for the fuel filter. (See Fuel Filter Cartridge in EVERY 500 HOURS SERVICE section.) -162-