Komatsu — TROUBLE SHOOTING GUIDE

Charge monitor does not light up when the engine is stationary. (When the starting switch is in ON position.) l Replace the monitor. l Check and repair the wiring. Outside the electrical intake air heater is not warm when touched with the hand. l Check and repair wiring. l Replace the electrical intake air heater. 0 Check and repair the heater switch. ENGINE The engine oil pressure monitor flashes when engine speed is raised after completion of warm-up. l Add the oil to the specified level. l Replace the oil filter cartridge. l Check oil leakage from the pipe or the joint. l Replace the monitor. Steam is emitted from the top part of the radiator (the pressure valve).

The radiator cooling water level monitor flashes. l Supply the cooling water and check leakage. 0 Adjust fan belt tension. l Wash out inside of cooling system. 0 Clean or repair the radiator fin. l Replace the thermostat. 0 Tighten the radiator cap firmly or replace the gasket of it. l Replace the monitor. The engine does not start when the starting motor is turned over. l Add fuel. l Replace the injection pump or the nozzle. 0 Check the valve clearance. 0 Check engine compression pressure. l Repair where air is leaking into fuel system. l Refer to the section of electrical system. Exhaust gas is white or blue. l Adjust to specified oil quantity. l Replace with specified fuel. - 167-