Komatsu — PC200, 200LC-5 MIGHTY (METHOD FOR HANDLING THE ATTACHMENTS)

1. Remove the bucket. For details of the procedure for removing the bucket, see INVERSION AND REPLACEMENT OF BUCKET in the operation manual for the stan- dard machine. Place the attachment in a horizontal position, then install to the arm with pin (A) and then pin (B). After installing the attachment, stop the engine. Then operate each con- trol lever and attachment control pedal to the front and rear, and left and right 2 or 3 times to the end of its stroke to release the remaining pressure inside the hydraulic circuit. After checking that the oil temperature is low, remove the blind covers from the inlet port and outlet port (2 places).

Be careful that no dirt or mud is stuck to the hose joint. If the O-ring is damaged, replace it with a new part. Turn the rotor of the stop valves installed to the inlet and outlet piping at the side of the arm to the ON position. After installing the attachment, check the oil level in the hydraulic tank. * 2. 3. 4. * 5. 6. - 196-