Komatsu — LOCKING CAP

LOCKING CAP Locks are installed to the fuel tank filler cap, hydraulic tank filler cap, operator’s cab, left side door (rear), and engine hood. t Use the starting key to open and close the cap. Open and close locking cap as follows: (For the fuel tank filler port) A: To open the cap 1. Insert the key into the cap. (a): OPEN (b): LOCK 2. Turn the key clockwise, align the match mark on the cap with the rotor groove, then remove the cap. B: To lock the cap 1. Turn the cap into place. 2. Turn the key counterclockwise and take the key out. (For the hydraulic tank filler port) C: To open the cap 1. Insert the key into the cap. (a): LOCK (b): OPEN 2.

Turn the key counterclockwise and bring the rotor groove in line with the aligning mark on the cap. Turn the cap slowly until a “clicking” sound is made. This releases the lock and allows the cap to be opened. (a): Aligning mark D: To lock the cap 1. Turn the cap into place. 2. Turn the key clockwise and take the key out. t When the cap is locked (against vandalism), it rotates freely. t Insert the key as far as it will go. If the key is turned before it is inserted all the way, it may break. (a): Shoulder - 22 -