CHECKING AND MAINTAINING CAR COOLER a. Check volume of refrigerant (gas) If there is a lack of refrigerant, the cooling performance will be poor. When operating the cooler at high speed, there should be no bubbles in the sight glass (inspection window) mounted on the condenser unit receiver. If there are any bubbles, there is a lack of gas, so have to add refrige- rant at a shop. (a): Sight glass (b): No refrigerant (c): Lack of refrigerant (d): Correct amount of refrigerant A The refrigerant used in the cooler is colorless and odorless, and is harmless when released into the atmosphere.
However if it gets in the eyes or on the hands, it will be cause of burn or loss of sight, so never loosen any part of the refrigerant circuit. b. Clogging of condenser If there is any dirt or mud stuck to the condenser, there will be a big re- duction in the cooling efficiency of the condenser. That will mean a reduc- tion in the cooling capacity, so clean the dirt and mud off and correct any bent fins with a screw-driver. c. Check during off-season When the cooler is not being used, run the compressor at low speed for a few minutes every week to avoid loss of oil.
(Run the engine at low speed with the cooler temperature control knob at LOW COOL.) * In cold weather, do not run the compressor suddenly at high speed. This may cause failure in the compressor. When the temperature is below 2 to 6.5”C, the low pressure cut-off switch functions to stop the compressor from running even when the cooler switch is turned on. d. Checking and adjusting V-belt tension Checking The slack should be 8 to 13 mm when pushed with a finger force of about 6 kg midway between the compressor pulley (1) and the crankshaft pulley (2). (3): Water pump pulley (4):
Alternator pulley Adjustment TO adjust, loosen bolt (5), then loosen locknut (6) and move adjustment bolt (8) with nut (7) to move the compressor. - 26 -