SWITCHES 1. STARTING SWITCH This switch is used to start or stop the engine. OFF Key insertion-withdrawal position. None of electrical circuits activate. ON Charging and lamp circuits activate. Keep key at ON after starting. START At this key position, the starting motor will crank the engine. Release key immediately after starting. HEAT Use this position when starting in cold weather. Release the key to allow it to return automatically to OFF and then, with- out delay, turn it to START. * When starting, be sure to use the starting key. 2. FUEL CONTROL DIAL (WITH AUTO-DECELERATION MECHANISM) This adjusts the engine speed and output. (1): Low idling (MIN) Turned fully to the left (2):
Full speed (MAX) Turned fully to the right t To stop the engine, turn the starting switch to the OFF position. 3. WINDOW WASHER While the switch is being held at the ON position, washer fluid is sprayed out. When the switch is released, it will return automatically to the OFF position and the supply of washer fluid will stop. t Do not keep the switch at the ON position for more than IO seconds con- tinuously. * Do not operate the switch to the ON position if there is no more washer fluid. (f): Front of machine - 22 -