Komatsu — TRANSPORTATION

TRANSPORTATION When transporting the machine, observe the various road rules, road transportation vehicle laws and vehicle limit ordinances, etc. It is a good idea to obtain a special platform for loading and unloading the machine. When it is unavoidably necessary to use a gangplank, however, at the very least observe the following for the sake of safety. 1. Properly apply the brakes on the trailer and insert blocks (a) beneath the tires to ensure that it does not move. Then fix gangplank (b) in line with the cen- ters of the trailer and the machine. t Make sure the gangplank has sufficient width, length and thickness to enable the machine to be safely loaded and unloaded.

If the gangplank sags appreciably, reinforce it with blocks, etc. * Make angle (c) of the gangplank a maximum of 15”. * Set distance (d) between the gangplanks to match the center of the tracks. A Remove the mud from the undercarriage to prevent the machine from slip- ping to the side on slopes. Set the travel speed switch to the Lo position. Turn the AUTO-DECEL switch OFF, and return the fuel control dial to reduce the engine speed. Turn the swing lock switch ON to apply the swing lock. Set in the direction of the gangplank, lower the work equipment as far as possible without letting it hit the trailer, then travel slowly to load or unload the machine.

When on the gangplank, do not operate any lever other than the travel lever. When the work equipment is installed, load the machine from the front; when the work equipment is not installed, load the machine from the rear. A Never change the direction of travel when on the gangplank. If it is necess- ary to change direction, drive off the gangplank and correct the direction, then drive on to the gangplank again. Load the machine correctly in the specified position on the trailer. After loading the machine, fully extend the bucket and arm cylinders, then slowly lower the boom.

* When transporting the machine, place rectangular timber under one end of the bucket cylinder to prevent it touching the ground, thereby saving it from possible damage. When transporting the machine, place rectangular timber underneath the front and rear track shoes to prevent the machine from moving about. Also, hold it down with chains or rope. Be particularly careful to ensure that the machine does not slip sideways. Lock all the control levers securely with the lock lever. A When loading the machine, park the trailer on a flat firm roadbed. Keep a fairly long distance between the road shoulder and the machine.

* Determine the route for transporting the machine by taking into account the width, height and weight of the machine. 2. 3. 4. 5. * * - 46 -