Komatsu — PRECAUTIONS FOR MAINTENANCE

PRECAUTIONS FOR MAINTENANCE SAFETY **-‘A 1. Wear well-fitting helmet, safety shoes and working clothes. When drill- ing, grinding or hammering, always wear protective goggles. 2. Fuel or oil are dangerous substances. Never handle fuel, oil, grease or oily clothes in places where there is any fire or flame. As preparation in case of fire, always know the location and directions for use of fire extinguishers and other fire-fighting equipment. 3. Do not handle electrical equipment while wearing wet gloves, or in wet places, as this can cause electric shock. 4. During maintenance do not allow any unauthorized person to stand near the machine. 5. Exhaust gas is dangerous.

When working inside, be particularly careful to have good ventilation. 6. Unless you have special instructions to the contrary, maintenance should always be carried out with the engine stopped. Apply the swing lock lever and also all of the safety levers. If maintenance is carried out with the engine running, there must be two men present: one sitting in the operator’s seat and the other one performing the maintenance. In such a case, never touch any moving part. 7. When working underneath the machine, place a sign to that effect on the operator’s seat and, if necessary, put a similar signs in the vicinity as well. 8.

Do not go underneath the machine after raising it up using the boom and the arm. 9. When working with others, choose a group leader and work according to his instructions. Do not perform any maintenance beyond the agreed work. 10. When maintenance has to be carried out with the work equipment raised, they must be securely supported by blocks. 11. Always remember that the hydraulic oil circuit is under pressure. When feeding or draining the oil or carrying out inspection and maintenance, release the pressure first. Method of relieving pressure 1) Lower the work equipment to the ground and stop the engine after id- ling it for two or three minutes. Then operate the various operation le- vers.

(work equipment, traveling and steering lever through their full stroke in each direction) When removing air instruments or pipings, open the drain valve under the air reservoir to relieve air pressure. 2) Gradually unscrew the cap of the hydraulic tank and leave it for a few minutes. -48-