Komatsu — STORAGE

STORAGE BEFORE STORAGE To place the machine in storage for an extended period of time, the fol- lowing measures must be taken to insure that it can be returned to oper- ation with minimum of service. After every part is washed and dried, the machine should be housed in a dry building. Never leave it outdoors. In case it is unavoidable to leave it outdoors, lay wood plates on the ground, and park the machine on the wood plates and cover it with can- vas, etc. Completely fill the fuel tank, lubricate and change the oil before storage. To protect the cylinder rod when the machine is not being used, set the work equipment in the posture shown in the diagram.

(This prevents rusting of the cylinder rod) Apply a thin coat of grease to metal surfaces (hydraulic piston rods and front idler adjusting rods). As for the batteries, remove the terminals and cover them, or remove them from the machine and store separately. When the ambient temperature is anticipated to drop below o”C, always add antifreeze in the cooling water. Lock all the control levers securely with the lock lever. DURING STORAGE 0 Operate the engine and move the machine for a short distance once a month so that a new film of oil will be coated over movable parts and component surfaces. 0 Before operating the working equipment, wipe off the grease on the hy- draulic piston rod.

A If it is unavoidably necessary to carry out the while the machine is indoors, open the doors vetilation and prevent gas poisoning. rust-preventive operation and windows to improve AFTER STORAGE Carry out the following procedure when taking term storage. the machine out of long- l Wipe off the grease on the hydraulic piston rod. 0 Completely fill fuel tank, lubricate and add oil. * If the machine is stored without carrying out the monthly rust prevention operation, request your Komatsu distributor for service. - 54 -