C: CHECKS AFTER STARTING After starting the engine, do not immediately start operations. First, carry out the following operations and checks. 1. Turn fuel control dial (1) to run the engine at a midrange speed, and run under no load for approx. 5 minutes. (a): Midrange speed 2. Push working mode switch (2) on the monitor panel to select H.0 (heavy- duty operation) mode. (The H.0 lamp above the working mode switch lights up) 3. Operate bucket control lever (3) and arm control lever (4) slowly to move the bucket cylinder and arm cylinder to the end of their stroke. (a): In (b): Out (c): Curl (d): Dump 4. Operate the bucket for 30 seconds and the arm for 30 seconds in turn fully for 5 minutes.
* When pulling in the work equipment, be careful not to hit the chassis or ground. t Turn the swing lock switch ON (ACTUATED) and operate the lever to make the oil temperature rise more quickly. 5. After the warming-up operation, check that all gauges and caution lamps are normal. * Run under light load until the engine water temperature gauge enters the green range. 6. Check that there is no abnormal exhaust gas color, noise, or vibration. * Do not suddenly accelerate the engine before the completion of the warming-up operation.
t The most suitable temperature for the hydraulic oil is 50 - 8O”C, but in order to extend the life of the machine, the temperature must be raised to at least 20°C before starting work. * Do not suddenly operate the levers when the hydraulic oil temperature is below 20°C. * Do not run the engine at low idling or high idling for more than 20 minutes. If it is necessary to run the engine at idling, apply a load or run at a mid-range speed from time to time. - 58 -