USING THE EXTENSION ARM (EXCEPT PC200, 2OOLC-5 MIGHTY) When the extension arm is installed, be careful when retracting the arm because the bucket hits the foot of the boom cylinder or the lower frame of the swing circle. (a): Prohibited zone to be operated Use the narrow bucket (width: 750 mm) without the side-cutter when installing the extension arm. When you use the standard width bucket, the machine stability is lost. Also the bucket will hit the cab when the arm is retracted. Work in hard soil or rocky terrain will shorten the life of the extension arm, the boom and the arm. It is better not to use the extension arm in such conditions.
HANDLING THE CLAMSHELL BUCKET (EXCEPT PC200, 2OOLC-5 MIGHTY) This bucket is used for digging and loading in side-ditches or the con- fined spaces. How to perform excavation Carry out digging work by lowering the boom keeping the clamshell op- ened. Close the bucket while raising the boom gradually. When you begin to dig and find the bucket rotating, do as follows. Extend the bucket cylinder fully and hold, the bucket will soon stop ro- tating. * Make the teeth of the bucket vertical in digging. * For safety, always avoid abrupt traveling, swing and stopping. * Do not swing the bucket to crush the rock or to cut through soil. * Do not use the bucket for hammering or pulling out piles etc.
* Before leaving the machine, open the bucket and lower it to the ground. * Remove the bucket from the arm when transporting the machine. - 84 -