Workshop Manual S3.8 Engine A030K288 (Issue 2) 01-2010 l eakages if any and screw on the hand primer knob fully. 17.Connect accelerator linkage. pump fuel inlet banjo to avoid fuel starvation. Caution : Ensure adequate tightness on feed REMOVAL AND INSTALLATION OF INJECTOR AND PROTECTIVE SLEEVE REMOVAL 1 Drain coolant from radiator and cylinder block. 2 Remove cylinder head cover. 3 Remove clamps holding high pressure lines. 4 Loosen the outer screw plugs sealing high pressure lines and remove inner screw plugs holding high pressure line in cylinder head. 5. Disconnect high pressure lines from injectors and delivery valve holders and slide high pressure lines away from injectors. Fig.
15 NOTE : Do not bend high pressure lines. 6. Unscrew leak off line banjo bolts along with sealing washer and remove leak off line assembly Fig. 14. Unscrew and remove pressure screw holding nozzle holder to the cylinder head with the help of socket, 000 589 0209. Fig. 15. 7. Remove nozzle holder with puller, 000 589 0119. Fig. 16. 8. Loosen protective sleeve in cylinder head with adaptor, 000 589 0309. Fig. 17. 9. Remove protective sleeve and its sealing ring from cylinder head. Fig. 16 Fi . g 17 Fig. 14 39 33