Doosan Mega 500-V (Tier II) — 023-00054E(M500V Tier II sn2000-Up)(023-00054Ecover.fm)

ALWAYS USE ADEQUATE EQUIPMENT SUPPORTS AND BLOCKING Do not allow weight or equipment loads to remain suspended. Lower everything to ground before leaving operator’s seat. Do not use hollow, cracked or unsteady, wobbling weight supports. Do not work under any equipment supported solely by a lift jack. DO NOT WORK ON HOT ENGINES OR HOT COOLING OR HYDRAULIC SYSTEMS Wait for engine to cool off after normal operation. Park wheel loader on a firm, level surface and lower all equipment before shutting down and switching "OFF" controls. When engine lube oil, gearbox lubricant or other fluids require change, wait for fluid temperatures to decrease to a moderate level before removing drain plugs.

NOTE: Oil will drain more quickly and completely if it is warm. Do not drain fluids at temperatures exceeding 95°C (203°F), however do not allow full cool-down. HYDRAULIC CYLINDER SEALS REQUIRE PERIODIC REPLACEMENT Check cylinder drift rate at regular intervals. Overhaul seal kits are available through Daewoo. HIGH PRESSURE HYDRAULIC LINES CAN STORE A GREAT DEAL OF ENERGY Exposed hydraulic hoses on arm or boom could react with explosive force if struck by a falling rock, overhead obstacle or other job site hazard. Extra safety guards may be required. NEVER allow hoses to be hit, bent or interfered with during operation. S0103010K Page 30 Wheel Loader Safety