Optional Equipment - Section 6 OM6007 8/00 Page 6-16 Payload Meter II DISPLAYS AT START-UP 7. The display will show: POWER ON: This display indicates the Machine ID code where “xxx” indicates a value between 0 and 200. ALL external display lamps (Figure 6-2) will come on and stay on for approximately 27 seconds during the “Power-up Process”. 8. The display will show: The “Power-up Process” will display the PLM settings. Each display will occur for approximately 3 seconds: This display indicates the Operator ID code where “xxx” indicates a value between 0 and 200. 9. The display will show: 1. The display will show:
This display indicates the Speed Limit setting where “xx” indicates a value between 0 and 99 km/h. In addition, a buzzer will sound and the following lamps will light for 3 seconds: Reception Pilot Lamp (2, Figure 6-1) 10. The display will show: Transmission Pilot Lamp (3, Figure 6-1) This display indicates the Option code setting. Memory Card Pilot Lamp (4, Figure 6-1) Refer to “Operator Check Mode, Setting the Op- tion Code” and to “Method of Operation” for more information on this function. 2. The display will show: The “xx” indicates the Truck Model. Refer to "Initial Setup of Payload Meter" for code defini- tions. 3. The display will show:
This display indicates the status of the Memory Card where: “Cd : - -” indicates Card Not Used, and “Cd : oo” indicates Card Is Used. If the truck engine is started before the preceding “Power-up Process” is completed, the display will shift to normal operation. NORMAL OPERATION 4. The display will show: This display indicates the status of the Inclinometer for the PLM, where If the engine is running when the payload meter starts up, only "o:XXX" and "d:XXX" will display before switching to normal operations. “CL : - -” indicates Inclinometer Not Used, and “CL : oo” indicates Inclinometer Is Used. 5. The display will show: This display indicates method of measurement where: "US :
- -" indicates METRIC Tons. "US : oo" indicates U.S. Tons. 6. The display will show: This function is not used. "SU : - -" indicates Switch 8 is up. "SU : oo" indicates Switch 8 is down.