MAINTENANCE PROCEDURE Some versions of the machine come with special safety drain plugs and to change the oil it is necessary to proceed as fol- lows. Remove the plug (7), apply the special union provided and screw manually until the oil flows out. At the same time, carry out the change procedures prescribed for the standard version. At the end of the operation, remove the special union and put it in the appropriate tool container. Put back the plug (7). 4.8.6.h CHANGING THE ENGINE OIL FILTER q Soon after the machine has been stopped the engine oil is very hot and may cause burns; let the engine cool down until it reaches a temperature of 40-45єC before draining the oil.
q The oil that may be spilled during the change makes the ground slippery, therefore, use anti-slip shoes and im- mediately remove any trace of oil from the floor. q Oils, filters, coolants and batteries are considered spe- cial waste and must be collected and disposed of ac- cording to the anti-pollution regulations in force. This operation must be carried out on every oil change. Proceed as follows: 1 - Raise the engine hood (see "3.5.1 ENGINE HOOD"). 2 - Lift the loader arm and secure it with the safety lock (see "3.1.1 LOADER LOCKS"). 3 - Drain the engine oil (see "4.8.6.g CHANGING THE ENGI- NE OIL"). 4 - Unscrew the used filter (1) with the special spanner provi- ded and discard it.
5 - Clean the contact surface between the seal and the filter support (2). 6 - Lubricate the seal of the new filter and screw thoroughly. 7 - Give a further half turn by hand. 8 - Fill the engine with new oil and complete the operations as described in "4.8.6.g CHANGING THE ENGINE OIL". Start the engine, make sure that there are no leakages and that the oil pressure warning light goes out. Close the engine hood. IMPORTANT q Do not use the spanner to lock the filter, since this may be damaged and cause oil leakages. 191 WARNING