MAINTENANCE PROCEDURE 4.8.8.b CHANGING THE HYDRAULIC OIL DRAIN FILTER q Soon after the machine has been stopped the hydraulic oil is very hot; let it cool down until it reaches a temper- ature of 40-45єC before changing the filter. q The hydraulic system is pressurized; loosen the filling cap slowly to release the residual pressure. q Oils, filters, coolants and batteries are considered spe- cial waste and must be collected and disposed of ac- cording to the anti-pollution regulations in force. q On new machines, change the hydraulic oil filter car- tridge after the first 250 hours of operation and succes- sively every 500 hours.
q On machines filled with synthetic biodegradable oil type HEES, the first change must be carried out after the first 50 hours of operation and the successive changes eve- ry 500 hours. The filter is positioned on the hydraulic system drain outlet and blocks the metal particles that come off the various componen- ts due to their wear. The filter can be reached after opening the rear panel (see "3.5.2 REAR PANEL"). To change it, proceed as follows: 1 - Slowly loosen the filling cap (1) in order to release the re- sidual pressure from the tank and then remove it. 2 - Unscrew the used filter (2) and discard it.
3 - Clean the contact surface between the seal and the filter support (3), lubricate the seal of the new filter and screw thoroughly. 4 - Give a further half turn by hand. 5 - Close the rear panel. IMPORTANT q Do not use the spanner to lock the filter, since this may be damaged and cause oil leakages. q If the machine contains synthetic biodegradable oil type HEES, the filter must be changed after the first 50 hours of operation. 194 WARNING CAUTION