John Deere 6059T — John Deere 6059T User Manual

ARMY TM 9-2815-256-24 AIR FORCE TO 38G1-96-2 MARINE CORPS TM 2815-24/5 FIGURE 3-89. Delivery Valve Replacement CAUTION Always use a new delivery valve stop (35, FIGURE 3-73). Installation of a used stop can result in leakage and low output at cranking speed. CAUTION Excessive tightening of screw (34) can cause seizure of hydraulic head and rotor assembly. Insufficient torque may cause leaking and hard starting. NOTE Tighten screw (34) 120 to 125 in-lbs. (13.6 to 14.1 Nm). j. Install delivery valve spring (36) and new delivery valve stop (35) in rotor bore. Using hex end of extractor (13383), install screw (34). NOTE' Tighten connectors 58 to 66 ft-lbs (78.6 to 89.5 Nm). k.

If removed, install six new fuel connectors (47) in head. I. If removed, install plungers (29) in their bores and check for freedom of movement. Install four shoes (28) and rollers (27) on rotor, refer to FIGURE 3-90. m. Remove rotor from holding fixture and submerge it in clean calibrating oil. CAUTION Do not force Plungers into bore. Never attempt to press a roller into a shoe from outer edges, as groove width at this point is less than roller outside diameter and shoe breakage can result. 3-108