ARMY TM 9-2815-256-24 AIR FORCE TO 38G1-96-2 MARINE CORPS TM 2815-24/5 FIGURE 3-93. Installing Protection Tube aj. Place governor arm (44, FIGURE 3-64) into Position in housing. Insert governor shaft (78) through hole in housing so knife edge mates with groove in governor arm, refer to FIGURE 3-94. NOTE Tighten nuts (76, FIGURE 3-64) successively 10 to 15 in-lbs (1.1 to 1.7 Nm). The nut on technician's right is torqued last. ak. Install new seals (77, FIGURE 3-64) on each end of pivot shaft and install nuts (76). FIGURE 3-94. Installing Governor Arm al. Install six weights (18, FIGURE 3-73) into weight retainer (33), refer to FIGURE 3-95. 3-113