John Deere 6059T — John Deere 6059T User Manual

ARMY TM 9-2815-256-24 AIR FORCE TO 38G1-96-2 MARINE CORPS TM 2815-24/5 FIGURE 3-135. Spring Pin Protrusion CAUTION Upper and lower idler gear sleeve bearings (4 and 12, FIGURE 3-134) have the same ID, but are different. Sleeve bearing with spiral oil groove goes in lower idler gear. Sleeve bearing without groove goes in upper idler gear (pressure lubed). Do not intermix sleeve bearings or premature sleeve bearing failure will result. d. If sleeve bearings (4 and 12) were removed, use an arbor press, driver (JD-252), and handle (10914188) to install sleeve bearing (4) in idler gear (3) and sleeve bearing (12) in idler gear (11). e.

Install lower idler gear (11), thrust washer (10), and nut (8). f. Time camshaft and install upper idler gear (3), thrust washer (2), and capscrew (1), refer to paragraph 3-40.3. g. Install oil pan, refer to paragraph 3-20.3. h. Install timing gear cover, refer to paragraph 3-39.3. 3-42. FRONT PLATE. 3-42.1. Removal. a. Remove timing gear cover, refer to paragraph 3-39.1. b. Remove camshaft, refer to paragraph 3-40.1. c. Remove fuel injection pump and drive gear, refer to paragraph 3-27.1. d. Remove oil pump and drive gear, refer to paragraph 3-21.1. e. Remove idler gears, refer to paragraph 3-41.1. f.

Remove five screws (1, FIGURE 3-136) and lockwashers (2) securing front plate (3); remove front plate (3) and gasket (4). Discard gasket (4) and lockwashers (2). g. Remove oil bypass valve (6) and spring (5). h. If new front plate (3) is to be installed, remove setscrew plugs (7). Discard plugs. Change 3 3-176