John Deere 6059T — John Deere 6059T User Manual

ARMY TM 9-2815-256-24 AIR FORCE TO 38G1-9-2 MARINE CORPS TM 2815-24/5 FIGURE 3-159. Measuring Camshaft Bore Diameter (6) Measure cylinder block top deck flatness using precision straightedge, refer to FIGURE 3-160. New flatness is 0.003 inch (0.08 mm). If flatness is not as specified, resurface engine block. FIGURE 3-160. Measuring Cylinder Block Top Deck Flatness CAUTION When cylinder block is machined (top deck or crankshaft bearing bores), the dimension from centerline of crankshaft bearing bore to top deck will be changed. Make sure that this dimension will not be less than 11.889 inches (301.98 mm). Otherwise, piston may contact cylinder head.

CAUTION If cylinder block top deck is resurfaced, also measure depth of liner counter bores. Bore depth must be within 0.234 to 0.236 inch (5.95 to 5.99 mm). 3-207