John Deere 6059T — John Deere 6059T User Manual

ARMY TM 9-2815-256-24 AIR FORCE TO 38G1-96-2 MARINE CORPS TM 2815-24/5 d. Column 4 Maintenance Level. Column 4 specifies, by the listing of a work time figure in the appropriate subcolumn(s), the level of maintenance authorized to perform the function listed in Column 3. This figure represents the active time required to perform that maintenance function at the indicated level of maintenance. If the number or complexity of the tasks within the listed maintenance function varies at different maintenance levels, appropriate work time figures will be shown for each level.

The work time figure represents the average time required to restore an item (assembly, subassembly, component, module, end item, or system) to a serviceable condition under typical field operating conditions. This time includes preparation time (including any necessary disassembly/assembly time), troubleshooting/fault location time, and quality assurance/quality control time in addition to the time required to perform the specific tasks identified for the maintenance functions authorized in the maintenance allocation chart. The symbol designations for the various maintenance levels are as follows:

C...Operator or Crew O...Unit Maintenance F...Direct Support Maintenance H...General Support Maintenance D...Depot Maintenance e. Column 5 Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual tools) and special tools, TMDE, and support equipment required to perform the designated function. f. Column 6 Remarks. This column shall, when applicable, contain a letter code, in alphabetic order, which shall be keyed to the remarks contained in section IV. B-4 EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS. SECTION III . a. Column I Reference Code.

The tool and test equipment reference code correlates with a code used in the MAC, section II, column 5. b. Column 2 Maintenance Level. The lowest level of maintenance authorized to use the tool or test equipment. c. Column 3 Nomenclature. Name or identification of the tool or test equipment. d. Column 4 National Stock Number. The National stock number of the tool or test equipment. e. Column 5 Tool Number. The manufacturer's part number. B-5 EXPLANATION OF COLUMNS IN REMARKS, SECTION IV. a. Column I Reference Code. The code recorded in column 6, section II. b. Column 2 Remarks.

This column lists information pertinent to the maintenance function being performed as indicated in the MAC, section II. B-3