ARMY TM 9-2815-256-24 AIR FORCE TO 38G1-96-2 MARINE CORPS TM 2815-24/5 FIGURE 3-27. Measuring Commutator OD c. Measure commutator segment mica depth as shown in FIGURE 3-28. If depth is less than 0.0079 inch (0.2 mm), undercut the mica. FIGURE 3-28. Measuring Segment Mica Depth d. Check commutator surface for bum spots. This usually indicates an open circuit. Remove these spots using #400 abrasive paper. e. Inspect bearings (34 and 35, FIGURE 3-15) for wear and damage. If damaged or worn replace bearings using a press, refer to FIGURE 3-29. 3-44