SERIES 60 ON-HIGHWAY ENGINE OPERATOR'S GUIDE the gaskets touch the mounting adaptor head. Tighten filters an additional two-thirds turn by hand, or as indicated on the filter. PERSONAL INJURY To avoid injury from slipping and falling, immediately clean up any spilled liquids. 7. Add oil as required to bring the level to the Full mark on the dipstick. 1. Place a suitable container under the engine oil pan, remove drain plug and drain the lubricating oil. Replace the drain plug and tighten securely. PERSONAL INJURY 2. Remove spin-on filters using tool J 29917 or equivalent and a 1/2-in. drive socket wrench and extension.
Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. 3. Dispose of used oil and filters in an environmentally responsible manner, according to federal (EPA) and/or state recommendations. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. 4. Clean the filter gasket-contact surface of the adaptor head with a clean, lint-free cloth. Do not modify or tamper with the exhaust system or emission control system. 5. Fill the new filters with clean lubricating oil and lightly coat the filter gaskets with the same oil. 8.
Start and run the engine for a short period and check for leaks. After any leaks have been corrected, stop the engine long enough for oil from various parts of the engine to drain back to the crankcase (approximately 20 minutes). Add oil as required to NOTICE: Overtightening the filter may crack or distort the filter adaptor. 6. Start the new filters on the adaptor head and tighten by hand until All information subject to change without notice. 79 DDC-SVC-MAN-0039 Copyright © 2009 DETROIT DIESEL CORPORATION