OPERATION WORK OPERATIONS Always hang a warning sign on the work equipment control levers (A) and set the work equipment lock lever (4) to the LOCK position (L). Accumulation of flammable materials and leakage of fuel or oil around the battery or high-temperature parts of the engine, such as the engine muffler and turbocharger, may cause fire on the machine. Check thoroughly and repair any problems that are found, or contact your Komatsu distributor. Always repair any damage to the handrails and steps, and tighten any loose bolts. Failure to do this may cause workers to fall and suffer serious personal injury.
Walk-Around Check Before starting your machine and proceeding with any work operations: Check the area around and under the machine. Check for loose nuts and bolts, damage to any parts, leakage of fuel, oil, or coolant. Check the condition of the work equipment and the hydraulic systems. Check for looseness or play in electric wiring. Check that there is no dust accumulated around high-temperature parts. Precautions Before Starting Work Operations Before starting work operations, it is important to perform several procedures to be sure your equipment is in a safe operating condition. It is also important to be aware of the hazards involved when operating your machine.
If the machine is at an angle, reposition it so that it is level before starting your check. Perform the following inspections and cleaning every day before starting the engine for the day’s work. 1. Check for damage, wear, play in the work equipment, cylinders, linkage, and hoses. Repair any abnormality. Check that there are no cracks, excessive wear, or play in the work equipment, cylinders, linkage, or hoses. 2. Remove dirt and dust from around engine, battery, and radiator. Check for flammable material (dead leaves, twigs, etc.) accumulated around the battery, engine muffler, turbocharger, or other high-temperature engine parts.
Check if there is any dirt or dust accumulated around the engine or radiator. Remove all such dirt, dust, or flammable material. 3. Check for coolant or oil leaks around the engine. Check that there are no oil leaks from the engine or coolant leaks from the cooling system. If there are any leaks, repair it or replace the damaged parts. 2-76 WA430-6