Komatsu — Check Additional Water Separator, Drain Water

3. Check if there is any water accumulated in water separator (4). OPERATION 4. If there is any water accumulated, loosen air bleeding plug (5) (width across flats: 13 mm (0.5 in)), then loosen drain valve (6) of the water separator and drain the water. 5. Tighten air bleeding plug (5) and drain valve (6). Tightening torque: Air bleeding plug: . . . . . . . . . . . . . . 8.0 – 12.0 N•m (71 – 106 lbf in) Drain valve: . . . . . . . . . . . . . . . . . . . . 2.0 – 3.0 N•m (18 – 27 lbf in) When the engine is started after adding fuel, the water separator and fuel prefilter cup may become filled with water. If they become full of water, drain the water.

See “Check Water Separator, Drain Water” on page 2-83. WA430-6 2-85