Komatsu — RECOMMENDED FUEL, COOLANT, AND LUBRICANTS

MAINTENANCE RECOMMENDED FUEL, COOLANT, AND LUBRICANTS In order to keep your machine in the best condition for long periods of time, it is essential to follow the instructions in this manual. Failure to follow these recommendations may result in the shortened life or excess wear of the engine, power train, cooling system, and/or other components. Commercially available lubricants and additives may be good for the machine, but they may also cause harm. Komatsu does not recommend any commercially available lubricants and/or additives. Komatsu genuine oils are formulated to maintain the reliability and durability of Komatsu construction equipment.

Use the oil recommended according to the ambient temperature listed in the “Fuel, Coolant, and Lubricant Ambient Temperature Chart” on page 3-13. Specified capacity means the total amount of oil in the tank and the piping. Refill capacity means the amount of oil required to refill the system during inspection and maintenance. When starting the engine in temperatures below 0 o C (32 o F), be sure to use the recommended multi-grade oil, even if the ambient temperature may become higher during the course of the day. If the machine is operated at a temperature below -20 o C (-4 o F), a separate device is required. Consult your Komatsu distributor.

Always use the fuel specified for the ambient temperature. If the fuel is used at temperatures lower than the specified temperature (particularly at temperatures below -15°C (5°F)), the fuel will solidify. If the fuel is used at temperatures higher than the specified temperature, the viscosity will drop; this may result in problems such as a drop in output. When the fuel sulfur content is less than 0.2%, change the engine oil according to the period inspection table given in this manual. If the fuel sulfur content is more than 0.2%, change the oil according to the following table.

If these fuels are used, serious problems may occur because of early deterioration of engine oil or early wear of the engine’s internal parts. If the local situation makes it necessary to use these fuels, be sure to do the following: Check Total Basic Number (TBN) of oil frequently using a TBN handy checker, etc., and change oil based on the results. Always be aware that the oil change interval is much shorter than the standard interval. Be sure to have the Komatsu distributor’s expert perform periodic engine inspections, since change intervals of periodic replacement parts and overhaul intervals are also shorter.

3-12 WA430-6 Sulfur Content (%) Oil Change Interval Less than 0.5 500 hours 0.5 – 1.0 250 hours 1.0 and up Not recommendable (★)