Komatsu — Torque List

MAINTENANCE STANDARD TIGHTENING TORQUES FOR BOLTS AND NUTS Torque List If nuts, bolts, or other parts are not tightened to the specified torque, it will cause looseness or damage to the tightened parts. This will cause failure of the machine or problems with operation. Always pay careful attention when tightening parts. Unless otherwise specified, tighten the metric nuts and bolts to the torque shown in the following table. If it is necessary to replace any nut or bolt, always use a Komatsu genuine part of the same size as the part that was replaced.

3-20 WA430-6 Thread Diameter of Bolt (a) Width across Flats (b) Tightening Torque Target Value Service Limit mm mm N•m kgm lbf ft N•m kgm lbf ft 6 10 13.2 1.3 9.7 11.8 – 14.7 1.2 – 1.5 8.7 – 10.8 8 13 31 3.2 22.9 27 – 34 2.8 – 3.5 19.9 – 25.1 10 17 66 6.7 48.7 59 – 74 6.0 – 7.5 43.5 – 54.6 12 19 113 11.5 83.3 98 – 123 10.0 – 12.5 72.3 – 90.7 14 22 172 17.5 126.9 153 – 190 15.6 – 19.4 112.8 – 140.1 16 24 260 26.5 191.8 235 – 285 24.0 – 29.1 173.3 – 210.2 18 27 360 36.7 265.5 320 – 400 32.6 – 40.8 236.0 – 295.0 20 30 510 52.0 376.2 455 – 565 46.4 – 57.6 335.6 – 416.7 22 32 688 70.2 507.4 610 – 765 62.2 – 78.0 450.0 – 564.2 24 36 883 90.0 651.3 785 – 980 80.0 – 100.0 579.0 – 722.8 27 41 1295 132.1 955.1 1150 – 1440 117.3 – 146.8 848.2 – 1062.1 30 46 1720 175.4 1268.6 1520 – 1910 155.0 – 194.8 1121.1 – 1408.7 33 50 2210 225.4 1630.0 1960 – 2450 199.9 – 249.8 1445.6 – 1807.0 36 55 2750 280.4 2028.3 2450 – 3040 249.8 – 310.0 1807.0 – 2242.2 39 60 3280 334.5 2419.2 2890 – 3630 294.7 – 370.2 2131.6 – 2677.3