MAINTENANCE 6. After cleaning, install the element to the breather. When doing this, be careful not to mistake the direction of installation. Set so that the surface with the mark shown in (6) is at the top, then install. 7. Install the cover (4). 8. Tighten nut (3). Tightening torque:. . . . . . . . . . . . . . . . 10 – 14 N•m (89 – 124 lbf in) 9. Close engine side cover (1) on the left of the machine. Remark If the element is excessively dirty, or if it is damaged, replace it with a new part. 3-56 WA430-6