Komatsu — CHECK BEFORE STARTING

. LOADING SHOVEL MAINTENANCE MAINTENANCE Check Oil Level in Hydraulic Tank, Add Oil WARNING may cause burns. Wait for the in 7 - 16 CHECK BEFORE STAR Always c heck the items in thi s section before starti ng the engine temper ature to go down befor e starting the work. When removing the oil filler c ap, turn it slowly to relea se the internal pressure, the n remove it 1. Set t he work equipment in the posture shown in t he diagram o the r ight, then check the oil level and add oil if n ecessary. 2.

If wo rk equipment is not i n the condition shown in diagram o the r buck cont ight, start engine, r un at low idle, retrac t the arm an et cylinders, then lo wer the boom, set b ucket teeth e, move eac act with the ground, and stop the engine. 3. With in 15 seconds afte r stopping the engin cont in all rol lever (for work eq uipment and travel) to the full strok directions to release the internal pressure . 4. Che ck sight gauge (G). T he oil level should be between the and L marks. 5. If the level is below the L m ark, add oil through oi l filler (F) at th top o f the hydraulic tank. REMARK The oil le vel will vary depend ing upon the oil tempe Accordin gly, use the followin g as a guide:

Befor e starting operation: Between H and L leve (Oil te mperature 10 to 30° C (50 to 86°F)) H level C (122 to 176°F)) Norm al operation: Around (Oil te mperature 50 to 80°