OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Engine Oil Pan, Add Oil Engine parts and oil are at high temperature immediately after the engine is stopped, and will cause seri ous burns. Wait for the temperature to cool down before starting the operation. REMARK If the machine is at an angle, reposition it to level before checking. When checking the oil level after the engine has been operated, allow the engine to cool for 15 minutes before checking. 1. Open the engine rear cover. 2. Remove dipstick (G) and wipe the oil off with a cloth. 3. Completely insert dipstick (G) into the oil filler pipe, then remove it and check the oil level. 4.
The oil level should be between the H and L marks on dip stick (G). If the oil level is below the L mark, add oil through oil filler (F). 5. If the oil is above the H mark, remove the undercover under the machine, drain the excess oil from drain plug (P), then check the oil level again. 6. If the oil level is correct, tighten the oil filler, then close the engine rear cover. 7. Install the undercover. 3-43 WARNING