OPERATION MACHINE OPERATIONS AND CONTROLS Warming-up Operation 3 NOTICE q When the hydraulic oil is at a low temperature, do not carry out operations or move the lever suddenly. Always carry out the warming-up operation. This will help to extend the machine life. q Do not suddenly accelerate the engine before the warming-up operation is completed. Do not run the engine at low idling or high idling continuously for more than 20 minutes. After starting the engine, do not immediately start operations. First, carry out the following operations and checks. 1.
Pull fuel control lever (1) from low idling (position A) to mid way position (B) between full speed and low idling to raise the engine speed to a mid-range speed, then run under no load for approx. 5 minutes. REMARK When the ambient temperature is below 0°C (32°F), keep the fuel control lever close to the 1/4 position when carrying out the warming-up operation. 2. Set safety lock lever (2) to FREE position (F), then raise the bucket from the ground. Machine equipped with canopy Machine equipped with cab REMARK For machines equipped with a cab, there is only a safety lock lever on the left. 3-59