MACHINE OPERATIONS AND CONTROLS OPERATION q When the machine is traveling at high speed, travel speed boost monitor (5) lights up. For details of the travel speed values, see Section SPECIFICATIONS (5-2). REMARK When the engine is started, the travel speed is automatically set to low speed. When traveling at high speed, if the machine travels on soft ground or up a slope and the load increases, the travel is automatically switched to low speed travel, so there is no need to operate the switch. The travel speed boost monitor displays stays lighted up. When the load is reduced, the travel system returns to high speed travel. 5. Check that the travel alarm sounds.
If the alarm dose not sounds, please contact your Komatsu distributor for repairs. Moving Machine Backward 3 1. Set safety lock lever (2) to FREE position (F), then raise the work equipment to a position 40 - 50 cm (15.8 - 19.7 in) above the ground. 2. Raise the blade. 3. Opearate the both travel levers (3) as explained below. q When the sprocket (A) is at the rear of the machine. Pull levers (3) backward slowly to move the machine off. 3-64