Komatsu — Securing Machine

OPERATION TRANSPORTATION Securing Machine 3 After placing the machine on the specified position of the trailer, secure it according to the following procedure. NOTICE To prevent damage to the bucket cylinder during transpor­ tation, fit a wooden block at one end of the bucket cylinder to prevent it from touching the floor. 1. Lower the blade. 2. Extend the bucket and arm cylinders fully, then lower the boom slowly. 3. Stop the engine, then remove the key from the starting switch. 4. Set the safety lock lever to the LOCK position (L). REMARK For machines equipped with a cab, there is only a safety lock lever on the left. 5. Lock the sliding door (cab specification) and covers with locks.

See Section “Opening and Closing Covers with Lock (3-28)“. NOTICE Do not use the hole at the back of the track frame for tow­ ing or lifting the machine. 6. Place blocks under both ends of the tracks to prevent the machine from moving during transportation, and secure the machine with chains or wire rope of suitable strength. Be particulary careful to secure the machine in position so it does not slip to the side. When securing with a chain or wire rope, use the hole at the rear of the track frame and the hole in the blade side plate. 3-95