OPERATION TROUBLES AND ACTIONS Battery Removal and Installation 3 NOTICE After securing the battery, check that it does not move. If it moves, tighten it again securely. q Before removing the battery, remove the ground cable (normally connected to the negative (-) terminal). If any tool touches between the positive terminal and the chassis, there is a hazard of sparks being generated. q When installing the battery, connect the ground cable last. q Install the battery securely to the determined place. When doing this, be careful not to let the clamps contact the terminals. q When replacing the battery, fix the new battery securely in position with battery mounting clamp (1).
Tightening torque of mounting nut (2) is 4.9 to 5.9Nm (0.5 to 0.6kg·m or 3.6 to 4.3 ftlb). q Make sure that the cover on top of the battery covers the battery completely. Do not let it roll back. If the cover is damaged, replace it immediately. q If there is salt on the battery terminals, wash with water of a temperature of approx. 40°C (104°F), then dry completely and remove with a wire brush. 3-109