OPERATION TROUBLES AND ACTIONS Engine 3 q ( ): Always contact your Komatsu distributor when dealing with these items. q In cases of abnormalities or causes which are not listed below, contact your Komatsu distributor for repairs.
3-115 Problem Main causes Remedy Engine oil pressure monitor flashes (buzzer sounds at same time) •Engine oil pan oil level is low (sucking in air) •Clogged oil filter cartridge •Defective tightening of oil pipe joint, oil leakage from damaged part •Defective engine oil pressure sensor •Add oil specified level, see CHECK BEFORE STARTING •Replace cartridge, see EVERY 500 HOURS SERVICE (•Check, repair) (•Replace sensor) Steam is emitted from top part of rediator (pressure valve) •Cooling waterlevel low, water leakage •Loosen fan belt •Dirt or scale accumulated in cooling system •Clogging radiator fin or damaged fin •Defective thermostat •Loosen radiator filler cap (high altitude operation) •Defective water level sensor •Add cooling water,repair, see CHECK BEFORE STARTING •Adjust fan belt tension, see EVERY 500 HOURS SERVICE •Change cooling water, clean inside of cooling system, see WHEN REQUIRED •Clean or repair,see EVERY 500 HOURS SERVICE (•Replace themostat) •Tighten cap or replace packing (•Replace sensor) Engine water temperature gauge indicator is in red range (at same time, pilot lamp flashes and buzzer sounds) Even when engine is run for a long time, engine water tempera ture gauge indicator does not enter correct range •Defective thermostat •Monitor defective (•Replace thermostat) (•replace monitor) Even when water temperature gauge indicator is in correct range, pilot lamp flashes •Defective thermostat (•Replace thermostat) Engine does not start when start ing motor is turned •Lack of fuel •Air in fuel system •Water in fuel system •Defective fuel injection pump or noz zle •Staring motor cracks engine sluggishly •Engine pre-heating monitor does not lights up •Defective compression •Defective valve clearance •Add fuel, see CHECK BEFORE STARTING •Repair place where air is sucked in, see EVERY 500 HOURS SERVICE •Drain water from system, see WHEN REQUIRED and CHECK BEFORE STARTING (•Replace pump or nozzle) •See ELECTRICAL SYSTEM •See ELECTRICAL SYSTEM (•Adjust valve clearance) Exhaust gas is whiter or blue •Too mach oil in oil pan •Improper fuel •Add oil specified level, see CHECK BEFORE STARTING •Change to specified fuel