Komatsu — CHECK AND TIGHTEN TRACK SHOE BOLTS

MAINTENANCE PROCEDURE MAINTENANCE DRAIN WATER AND SEDIMENT FROM FUEL TANK 4 NOTICE Never use trichlene for washing the inside of the tank. Use diesel fuel only. Carry out this procedure before operating the machine. q Prepare a container to catch the fuel that is drained. 1. Swing the upper structure so that drain valve (1) is between the tracks. 2. Open the engine rear cover and cooling cover. For details, see Section “COOLING COVER (3-30)“. 3. Open drain valve (1) and drain the sediment and water col­ lected at the bottom together with the fuel. When doing this, be careful not to get fuel on yourself. 4. When only clean fuel comes out, tighten drain valve (3).

CHECK AND TIGHTEN TRACK SHOE BOLTS 4 (Machine equipped with road liner) If the machine is used with track shoe bolts (1) loose, they will break, so tighten any loose bolts immediately Tightening Tighten to a tightening torque of 127 to 142 N·m (13 to 14.5 kgf·m, 94 to 104.9 lbft) then check that the nut and shoe are in close contact with the link contact surface. Order for Tightening Tighten the bolts in the order shown in the diagram on the right. After tightening, check that the nut and shoe are in close con­ tact with the link mating surface. 4-28