MAINTENANCE PROCEDURE MAINTENANCE REPLACE FUEL FILTER CARTRIDGE 4 q Engine is at high temperature immediately after the machine has been operated. Wait for engine to cool down before replacing the filter. q Do not bring fire or sparks near the fuel. q Prepare a filter wrench q Prepare for cloth. 1. Open the engine rear cover. 2. Spread the cloth beneath the filter cartridge. 3. Set handle (1) of the water separator to CLOSED position (A). 4. Using a filter wrench, turn filter cartridge (2) counterclock wise to remove it. If any fuel spills, wipe it up immediately with a cloth. 5.
Clean the filter holder, fill the new filter cartridge with fuel, then coat the packing surface with fuel, and install to the fil ter holder. 6. When installing, turn to the right to tighten until the packing surface contacts the seal surface of the filter holder, then use a filter wrench to tighten approx. 1 turn. Tightening torque: 19.6 to 23.5 N·m (2.0 to 2.4 kgf·m, 14.5 to 17.4 lbft) 7. Set handle (1) of the water separator to OPEN position (B). 8. After replacing the fuel filter element, bleed air. For details of the procedure, see “Air Bleeding (4-51)“. 4-50 WARNING