MAINTENANCE PROCEDURE MAINTENANCE CHECK AND ADJUST COOLING FAN BELT TENSION 4 Checking 4 1. The deflection should be approx. 9 to 13 mm (0.355 to 0.5 in) when pressed at a point midway between the crank shaft pulley and the fan pulley with a finger pressure of approx. 98 N (10 kgf). REMARK As a guideline, there is no problem if the deflection is approx. 13 mm (0.5 in). Adjustment 4 q When this maintenance is carried out, it is necessary to open (tilt) the floor.
Before starting the operation to open the floor, read the precautions in Section “CAUTIONS FOR OPENING (TILTING) FLOOR (2-35)“ in the safety and maintenance sections thoroughly, and refer to the explanation for each part in Section “METHOD OF OPENING (TILTING) FLOOR (3-32)“ when carrying out the operation. Or ask your Komatsu distributor to carry out the maintenance. q Immediately after the engine is stopped, the parts and oil are at a high temperature, and will cause burns. Wait for the temperature to go down before starting the operation. q Prepare a pinch bar. q Prepare a wooden block. 1. When opening (tilting) the floor, see Section “When opening (tilt open) (3-32)“ for details. 2.
Insert a bar between alternator (1) and the cylinder block to fix alternator (1) in position. When fixing alternator (1) in position, insert a wooden block between the bar and alter nator (1) to prevent any damage to the alternator. 3. Loosen alternator adjustment bolt (2) and mounting bolts (3). 4. Move alternator (1) to adjust so that the belt tension is approx. 7 to 10 mm (0.276 to 0.4 in) when pressed at a point midway between the alternator pulley and the fan pul ley with a finger pressure of approx. 98 N (10 kgf). 5. Tighten adjustment bolt (2), then tighten mounting bolts (3) to secure alternator (1) in position. 6.
Check for damage to the pulleys, and wear of the V-groove and V-belt. Be particularly careful to check that the V-belt is not in contact with the bottom of the V-groove. 7. If the belt is stretched, leaving no allowance for adjustment, or if it is cut or cracked, contact your Komatsu dis tributor for replacement. 8. After completing the adjustment, close the floor. For details, see Section “When closing (tilt close) (3-35)“. 4-54 WARNING