Komatsu — LOCATIONS

ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT Quick Coupler This quick coupler (1) is used to connect the piping equipped with quick coupler at the attachment end. The following products are used for the quick coupler. Arm left side (hole end): STUCCHI (F FIRG12A BSP) Arm right side (shaft end): STUCCHI (APM15 3/4 BSP) When removing the attachment, install this coupler (1) to cap (A). When installing the attachment, remove cap (A), clean all the dirt from coupler (1), then connect the piping. The following products are used for quick coupler cap (A). Arm left side (hole end): STUCCHI (8151..004) Arm right side (shaft end):

STUCCHI (8151..009) Selector Valve This valve (2) switches the flow of hydraulic oil. Position (a): When using breaker Turn spool (A) to the left until it is stopped by the stopper. Position (b): When using general attachment Turn spool (A) to the right until it is stopped by the stopper. Width across face of square portion of spool (A): 9 mm (0.355 in) Attachment Control Pedal This pedal (3) is used to operate the attachment. Top of pedal depressed: Oil flows to right side of arm (hydraulic tank side). Bottom of pedal depressed: Oil flows to left side of arm (opera­ tor's seat side). 6-19