Komatsu — Hydraulic Circuit Connection

ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT HYDRAULIC CIRCUIT 6 Hydraulic Circuit Connection 6 NOTICE The pressure for the hydraulic equipment for the attachments used on this machine is set at 17.2 MPa (175 Kgf/cm2), so check the pressure resistance of the attachment Installed. When connecting the attachment, connect the hydraulic circuit as follows. 1. Lock the attachment control pedal with the pedal lock. 2. Remove the cap of the quick coupler. Be careful not to damage or lose the parts that are removed. 3. Connect the piping (quick coupler) supplied by the attachment manufacturer. The following products are used for the quick coupler. Arm left side (hole end):

STUCCHI (F FIRG12A BSP) Arm right side (shaft end): STUCCHI (APM15 3/4 BSP) The size of the quick coupler mounting screws for the elbow installed to the block is as follows. Left side of arm (hole side): G1/2 Right side of arm (shaft side): G3/4 REMARK If the quick coupler size does not match, please contact your Komatsu distributor. 6-21