Komatsu — SWITCHES

DETAILED CONTROLS AND GAUGES OPERATION Cab Heater Switch (Machines equipped with cab) This switch (5) is used to heat the operator's compartment. The flow rate of the hot air can be set to two levels. Position 0: Off Position 1: Weak Position 2: Strong Hot water from the engine is used to carry out heating, so heat­ ing is possible when the engine cooling water is hot. Windshield Wiper Switch (Machines equipped with cab) This switch (6) actuates the front window wiper. This is also used as the window washer switch. The switch is operated as follows. q Wiper only When the switch is set to position (B), the wiper is actu­ ated. Position (A): Wiper stopped Position (B):

Wiper actuated q Wiper and window washer When the wiper is working and the switch is kept pushed to position (B), washer fluid is sprayed out. When the switch is released, it returns, and only the wiper operates. REMARK Be careful of the following when operating the window washer. Do not keep the switch pushed in to the washer spray position for more than 10 seconds continuously. Do not press the switch to the washer spray position if the washer fluid tank is empty. 3-14