Komatsu — TOOL BOX

DETAILED CONTROLS AND GAUGES OPERATION BLOCK FUSE 3 If the starting motor does not turn even when the starting switch is turned to the ON position, block fuse (1) is probably blown, so open the cover at the right side of the machine and check or replace the fuse. This is at the top surface of the battery. For details of the method of opening and closing the cover on the right side of the machine, see Section “COOLING COVER (3-30)“. REMARK A block fuse is a large fuse wire installed to the circuit where a large-capacity current is flowing. It acts in the same way as a normal fuse to protect the electrical equipment and wiring from burning out under abnormal current.

OPERATION MANUAL STORAGE 3 NOTICE Except when opening the cover for some reason, always keep the cover locked. This is under the operator's seat. There is a box for keeping the Operation and Maintenance Manual in the rear of the operator's seat backrest. Keep the Operation and Maintenance Manual in the box so that it can be seen at any time. TOOL BOX 3 NOTICE Except when opening the cover for some reason, always keep the cover locked. Store the tools in this box. 3-38